2015 Pursuit 385 Offshore

DESCRIPTION

The Pursuit 385 Offshore combines the best of all worlds; the acceleration of a bass boat, outboards, and the fishability comfort for both long-range cruising and offshore fishing. Tuna Yacht has the optional and upgraded Yamaha F350 engines.

Tuna Yacht is well taken care of with ample fishing features everywhere. She has built-in stainless steel rod holders (32 in total – 6 are electric Burnewiin) a recirculating 50 gallon live well, 2 fish boxes, 2 20′ premium outriggers with carbon fiber poles, and lots of storage throughout.

Pursuit’s quality is unrivaled, utilizing an infused fiberglass foam-filled structural grid system that incorporates a molded finish. The entire boat is hand-laminated and the transom is reinforced extensively.

Going inside, there is enough room for meal prep and washing with a large stainless steel sink and corian countertops with edge lighting. Tuna Yacht has a 240V dual burner glass cooktop with touch controls and pop-up pot holders. She also features a stainless steel microwave, and Vitrifrigo DT series fridge and freezer.

Tuna Yacht has enough space to comfortably sleep four people across two double beds. The V-berth sleeps two adults and has ample storage all around the berth itself.

The head has a vacuum flush Dometic head with an 18 gallon holding tank and a macerator discharge pump. It also features a shower with molded in fiberglass shower seat and an acrylic shower door.

The owner has recently spent over $74,000 in upgrades in the steering systems via Yamaha Helmmaster and Dockmate, and has consistently kept up on any and all maintenance items.

Additional information:

• Exterior:
  • 32 total rod holders
    • 12 rod holders forward of the cockpit
    • 6 rod holders in the aft cockpit
    • 8 rod holders on the roof
    • 6 electric Burnewiin mounts
  • 2 outriggers with carbon fiber poles
  • 1 50 gal livewell
  • 2 temperature-controlled, insulated fishboxes/coolers
    • 75 gallon
    • 68 gallon
• Electronics:
  • 30A or 50A shore power service
  • Yamaha Helmmaster with joystick and split sticks
  • Dockmate control system
  • FLIR night vision camera – integrated w/ Garmin electronics
  • 2X Garmin GPSMap XSV MFDs (16″ each)
  • Garmin Panoptix Sonar
  • Garmin Digital Radar
  • KVH HD7 Tracvision Marine Satellite
  • Garmin seat control module
  • ICom IC-M506 VHF
  • Polk audio receiver with JL cockpit speakers throughout
  • Marine Airrr Electric Heat/AC
  • Jensen and Samsung TVs (2)
• Galley:
  • Kenyon 2-burner electric stovetop
  • Vitrifrigo DT Series fridge and freezer
  • Frigidaire Microwave
  • Double Sink
  • Kenyon electric BBQ in cockpit
• Head:
  • Dometic Vacuum Head
  • Dometic blackwater tank level monitor
  • Shower Stall
• Mechanical:
  • 3X Yamaha 350 Outboard engines
  • 8kw Fischer Panda Generator
    • Built-in 25 gal diesel tank
• Other:
  • Lewmar bow thruster
  • Lenco trim tabs
  • Panoptix controls
  • Lumishore EOS Mini
  • Fireboy engine fire suppression system
  • Webasto electric cockpit heater
  • Viking 6-person liferaft (serviced in 2022)
  • ACR Epirb
  • Livewell fill
  • Fish box macerator
  • Water witch high water alarm

Work Completed:

• Tuned and serviced motors (changed fuel, oil filters, gaskets, live and gear case oil, changed zincs) (12/2021)
• Replaced all three water pumps (12/2021)
• Removed and replaced oil seal and O-ring on motors (12/2021)
• Generator air/oil/fuel filters with 310hrs (1/2022)
• Viking life raft serviced (3/2022)
• Installed cell phone booster (4/2022)
• Install life raft on top and seal with 4200 (4/2022)
• Relaxed hydraulic steering fluid (4/2022)
• Removed old live well pump and installed new pump (6/2022)
• Replaced SS cyclone low pressure (6/2022)
• Removed and cleaned fuel injectors (8/2022)
• Replaced spark plugs and gaskets (8/2022)
• Serviced all theee motors (engine oil, fuel and oil filters, all gaskets, thermostats, spark plugs, water/fuel separator filters) (3/2022)
• Pulled props and greased shafts (3/2022)
• Reinstalled props with new cotter pins (3/2022)
• Replaced trim tab zincs (3/2022)
• Changed location of signal wire to correct location for underwater lights (3/2022)
• Replaced rotors on all motors (5/2023)
• Tune and service all engines (5/2023)
• Installed joystick piloting (10/2023) – $57K
  • Helmmaster EX/Joystick
• Added 3 bolt on actuator kits (10/2023)
• Time and service all motors (engine oil, oil filter, fuel filter, spark plugs, compression test, lower unit gear live, drain gasket (10/2023)
• Removed props and greased shafts reinstalled shaft (10/2023)
• Re-torque prop and installed new cotter pins (10/2023)
• Greased all zero fittings (10/2023)
• run motor with salt treatment and anti corrosion spray all on (10/2023)
• New bottom paint (1/2024)
• Diagnosed and fixed sonar not working (Ethernet cable) (4/2024)
• Installed Dockmate controller (4/2024) – $17K
• Replaced pressure fuel pump on port engine (9/2024)
• VSTs on center and starboard required cleaned and service on (9/2024)
• Replaced thermostats on all engines (9/2024)
• All external anodes replaced (9/2024)
• Replaced saddle zincs in all engines (9/2024)
• New Panda generator panel/board (replaced voltage motherboard and remote panel) in 2025